Updated November 2026
Quick facts
| Service call | $85 — credited toward the repair when you proceed |
|---|---|
| Warranty | 30-day labor · 90 days on parts we supply |
| Credentials | BEAR #A 50636 · EPA Section 608 Universal |
| Hours | Mon–Fri 09:00–19:00 Sat–Sun 10:00–16:00 |
About appliance service in Sherman Oaks
Sherman Oaks splits at Ventura Boulevard: the hills to the south climb into the Santa Monica Mountains, with Royal Woods and Longridge Estates among them, and the flats to the north fill with condos, townhomes and single-family homes. Our Sherman Oaks jobs so far run from built-in refrigerators and a double wall oven to a stacked washer, a gas water heater and AC work. Ask about available appointments; timing depends on scheduling and parts.
Neighborhoods served: Sherman Oaks Hills, Sherman Oaks Flats, Royal Woods, Longridge Estates, Chandler Estates.
ZIP codes: 91403, 91423.
Sherman Oaks appliance repair
We cover both Sherman Oaks ZIPs, 91403 and 91423, from Longridge Estates and Royal Woods in the hills to the condos and homes in the flats along Ventura Boulevard. Ask about available appointments; timing depends on scheduling and parts.
Refrigerators, ovens and laundry
The refrigerator jobs here include a built-in Miele side-by-side whose freezer had iced over: we defrosted it completely and replaced the evaporator fan and the drain-pan heater. A repeat customer’s Café double wall oven kept stopping on F97, and we pulled it fully out of its cabinet to replace the cooling fan between the ovens and the small board that counts its RPM. We work on Bosch dryers as well: in nearby North Hollywood, a heat-pump dryer showing error dr had lint and water clogging its drain and pump at the condensate tray. In neighboring Valley Village, a customer got partway through installing a new LG over-the-range microwave and stopped; our write-up of that job shows where it stood and what we changed to get it hung. In neighboring Studio City, a customer couldn’t get the two blowers out of her Viking wall-mount range hood, so we removed both and later put them back.
AC and heating repair in Sherman Oaks
An older R22 air conditioner here wouldn’t start its outdoor unit, and the system was completely empty. We pressurized it with a refrigerant tracer and nitrogen, and an electronic leak detector found the leak in the condenser coil. Because R22 is out of production, we recommended a matched new system rather than a top-off. Our other AC repair jobs in Sherman Oaks include an ECM condenser fan motor we replaced, which comes as one part with its control module, and a mini-split whose dirty filters we pulled for cleaning. In neighboring Valley Village, a mini-split job went past the filters: a leaking Daikin whose condensate pump was getting no water, with the drain pan outlet, the hose and the pump’s filter all plugged.
In winter we cover the heating side as well, including central gas furnaces and heat-pump heating. See furnace repair. On a rooftop Goodman package unit here, the furnace’s draft inducer motor had seized from age, and we replaced the whole inducer assembly.
Call (213) 205-2055
Or text a photo. Next door, our Studio City page lists the jobs we’ve done along the same stretch of Ventura Boulevard.
Documented jobs in Sherman Oaks
-
Gas water heater flashing a chamber-sensor error
- What the customer saw
- In March 2025 the status light on the control valve of a Sherman Oaks gas water heater was blinking an error code.
- What we found
- The code pointed to the chamber sensor at the combustion chamber. A meter showed its resistance had drifted out of range, so the gas control no longer accepted it.
- What we did
- We replaced that one sensor. The new part measured normal and the heater worked again, with no need to replace the gas control or the tank.
-
Empty R22 air conditioner with a leaking condenser coil
- What the customer saw
- An older air conditioner on R22 in Sherman Oaks would not start its outdoor unit, and the system turned out to be completely empty.
- What we found
- We pressurized it with a refrigerant tracer and nitrogen, and an electronic leak detector located the leak in the condenser coil, a part that cannot be patched reliably.
- What we did
- We recommended a matched new system with a new indoor coil instead of a top-off: R22 has been out of U.S. production since 2020 and new condensers run on other refrigerants.
-
GE Profile with a lit interior and a dead display
- What the customer saw
- A GE Profile refrigerator in Sherman Oaks had stopped cooling. The interior light still came on, but the temperature display stayed dark.
- What we found
- Behind the refrigerator, several capacitors on the main control board had domed tops, and a smaller one near the heat sink was swollen too.
- What we did
- We installed an identical board we had already rebuilt on the bench with high-temperature, low-ESR capacitors. The compressor and condenser fan started, the display responded again, and we cleaned the dusty condenser area.
-
Built-in Miele side-by-side with a frozen-over freezer
- What the customer saw
- In June 2026 a built-in Miele side-by-side refrigerator in Sherman Oaks had stopped cooling. Everything in the freezer section was frozen over.
- What we found
- The evaporator was buried in ice, and the evaporator fan had stopped working.
- What we did
- We defrosted the refrigerator completely, replaced the evaporator fan, and replaced the drain-pan heater, which comes as one assembly with the plastic drain pan. After that the refrigerator worked normally.
-
Café double wall oven stopping on an F97 error
- What the customer saw
- In July 2026 a repeat customer's Café electric double wall oven in Sherman Oaks showed an F97 error now and then. Each time, the whole oven stopped working.
- What we found
- F97 can point to several faults. Instead of either of the two control boards, we started with the least expensive likely part: the cooling fan between the ovens and the small board that counts its motor's RPM.
- What we did
- We pulled the oven fully out of its cabinet, replaced the fan and that board, and the error went away.
-
GE front-load washer that wouldn't start
- What the customer saw
- A GE front-load washer stacked under a dryer wouldn't start on any cycle. After the codes were cleared, 93, 92 and 38 kept coming back.
- What we found
- Per GE, 93 is a main board failure, 92 an inverter fault and 38 a vent damper fault. Unplugging the inverter's power changed nothing, and in test mode the water valve test made the board reset.
- What we did
- The first new board was defective and quit a few minutes into a real cycle. A second board, programmed for this model, ran rinse and spin.
-
Goodman package unit: seized inducer motor
- What the customer saw
- In early November 2026, the draft inducer motor on the gas furnace side of an older Goodman package unit on a Sherman Oaks roof had seized from age.
- What we found
- Without the inducer turning there's no draft for the pressure switch to prove, so the furnace can't light. On this unit the motor, the blower wheel and the metal housing come as one part.
- What we did
- We replaced the whole inducer assembly, and a new one with a Fasco motor went in.
Our recent work in Sherman Oaks




Frequently asked questions
-
How fast can you reach Sherman Oaks?
Same-day works in most cases, depending on the open arrival windows: call (213) 205-2055 early or book online and pick one. It's the same for Longridge Estates and Royal Woods in the hills as for the flats. Text a photo of the model-number sticker so we can bring the right part; having it with us decides whether the repair is finished on the first visit.
-
Do you service both Sherman Oaks Hills and Flats?
Yes — all of Sherman Oaks (91403, 91423), from Longridge Estates and Royal Woods in the hills to the condos and homes in the flats.
-
What appliance brands are common in Sherman Oaks?
We repair all the major brands. The Sherman Oaks jobs on this page include a GE Profile and a built-in Miele refrigerator, a Café double wall oven and a GE front-load washer.
-
Do you service condo buildings?
Yes. Sherman Oaks has many condo and townhome complexes. We coordinate with property management on building access, follow protocols for shared-wall buildings, and provide insurance documentation when required.
-
Is the Ventura Boulevard area covered?
Yes — the Sherman Oaks commercial corridor along Ventura Boulevard, including residential side streets. Restaurants and small commercial properties along Ventura are also serviced (commercial appliance repair available).
-
Service call cost?
$85, credited toward the repair when you proceed. Flat-rate quote upfront. 30-day labor warranty and 90 days on parts we supply.
-
Have you repaired furnaces and package units in Sherman Oaks?
Yes. On a rooftop Goodman package unit here, the draft inducer motor on the gas furnace side had seized from age. On that unit the motor, the blower wheel and the housing are one part, and we replaced the whole inducer assembly. The $85 service call is credited toward the repair if you go ahead.
Google reviews
★★★★★
Eric had a great and warmness about himself, efficient and knowledgeable awareness of the issues. Had accessed and completed the task in a minimal amount of time (12 minutes)
★★★★★
Refrigerator was checked thoroughly and repair ok ok
★★★★★
I’m very glad I had Ivan come to clean the extremely dirty hood over my stove. He came the same afternoon and did a very thorough job. After seeing how much work it was, I was very pleased with the price he charged me. I would definitely recommend this company.
Appliance trouble in Sherman Oaks? We're on it.
Or text a photo of your appliance so we can bring the right part to Sherman Oaks.
(213) 205-2055