Updated November 2026
Quick facts
| Service call | $85 — credited toward the repair when you proceed |
|---|---|
| Warranty | 30-day labor · 90 days on parts we supply |
| Credentials | BEAR #A 50636 · EPA Section 608 Universal |
| Hours | Mon–Fri 09:00–19:00 Sat–Sun 10:00–16:00 |
About appliance service in Santa Monica
North of Montana homes typically run premium Sub-Zero/Wolf/Miele suites. Ocean Park and Sunset Park show more mainstream Samsung/LG/GE installs. Pico and Mid-City have a mix including older Whirlpool/Kenmore in long-held family homes.
Neighborhoods served: North of Montana, Sunset Park, Ocean Park, Wilshire-Montana, Pico, Mid-City Santa Monica.
ZIP codes: 90401, 90402, 90403, 90404, 90405.
Santa Monica appliance repair
Premium and mainstream coexist
North of Montana and the higher-priced beach blocks favor Sub-Zero/Wolf/Miele full suites. Ocean Park, Sunset Park, and Pico are more typical mid-tier installs — Samsung, LG, GE, Whirlpool, KitchenAid. Older long-held Santa Monica family homes often retain 1990s-era appliances we service routinely thanks to strong parts availability. Heating is part of the work here too: a gas wall heater in Santa Monica with the pilot out and nothing lighting got a new thermopile and works now (see furnace and heater repair).
Restaurants and commercial kitchens
We also repair commercial refrigeration here. At one Santa Monica restaurant, a Turbo Air prep table read 78°F with no power at the compressor, and the fault was a burnt relay joint on the control board. See commercial refrigerator repair in Santa Monica.
Call (213) 205-2055
Or text a photo of your appliance with the model-number visible.
Documented jobs in Santa Monica
-
LG refrigerator whose compressor hummed but didn't pump
- What the customer saw
- An LG LFX25991ST in Santa Monica had quit cooling completely. Another company had condemned the compressor and then stopped answering.
- What we found
- The compressor still hummed but wasn't pumping refrigerant. We put a gauge on the system through a piercing valve, and with the compressor running it didn't build pressure.
- What we did
- We brazed in LG's updated compressor with a fresh filter-drier, pressure-tested with nitrogen, pulled a vacuum, recharged by weight and reflashed the control board so it runs the new part.
-
Heat pump with no refrigerant left in it
- What the customer saw
- A split system in Santa Monica running on R-410A wasn't cooling, and there wasn't a drop of refrigerant left in it.
- What we found
- A nitrogen test at 400 PSI found one leak, at the suction service valve. Someone had opened it so hard that the stem was cranked into its back seat, and it leaked there.
- What we did
- Instead of brazing in a new valve, we turned the stem in a little and opened it fully again without forcing it. The leak stopped, and we weighed in the full nameplate charge.
-
Turbo Air prep table at 78°F with no power to the compressor
- What the customer saw
- A restaurant's Turbo Air MST-48-N prep table read 78°F inside. The evaporator fan ran, but the compressor and condenser fan got no power.
- What we found
- The compressor connector read 0 volts across its pins and 120 volts from each pin to ground, pointing to an open neutral. On the back of the board, the relay's joint had burned out after a ring crack.
- What we did
- The board is hard to find, so we replaced the relay, restored the burnt contacts and resoldered the other joints. The compressor ran again, and the temperature started dropping.
-
Gas wall heater with the pilot out: a new thermopile
- What the customer saw
- Nothing worked on a gas wall heater in Santa Monica. The pilot wasn't burning, and nothing would ignite.
- What we found
- The thermopile was the part to replace. On many millivolt wall heaters it holds the pilot valve open and powers the main gas valve, so when it fails neither the pilot nor the burner stays lit; other heaters use a separate thermocouple for the pilot.
- What we did
- We replaced the thermopile, and the heater works now.
Our recent work in Santa Monica




Frequently asked questions
-
Do you service all of Santa Monica?
Yes — all Santa Monica ZIP codes (90401, 90402, 90403, 90404, 90405). North of Montana, Sunset Park, Ocean Park, Wilshire-Montana, Pico, Mid-City.
-
Does living near the beach wear out appliances faster?
We don't have Santa Monica data showing that indoor appliances fail sooner near the beach, so we don't recommend a different maintenance schedule for that reason. Clean the refrigerator condenser coils as your owner's manual recommends. If you see rust on a hinge, a washer cabinet or the dryer vent hood, mention it when you book so we can check it.
-
What brands are common in Santa Monica?
North of Montana and the higher-priced beach-adjacent homes favor Sub-Zero/Wolf/Miele suites. Ocean Park, Sunset Park, and Pico are more mixed — Samsung, LG, GE, Whirlpool, KitchenAid are common. Older Santa Monica family homes often retain 1990s-era Kenmore or GE appliances that we service routinely.
-
Do you service rental properties in Santa Monica?
Yes. Santa Monica has a large rental market and we work with property managers on appliance repair contracts. We provide clear documentation for tenant landlord claims and direct billing arrangements for established property management relationships.
-
Do you repair restaurant refrigeration in Santa Monica?
Yes. We repair prep tables, reach-ins and other commercial refrigeration for Santa Monica restaurants. On a recent job, a Turbo Air prep table read 78°F because a burnt relay joint on its control board had cut power to the compressor, and we repaired the board.
-
Do you repair gas wall heaters in Santa Monica?
Yes. Here, a gas wall heater wasn't working at all: the pilot wasn't burning and nothing would ignite. We replaced the thermopile, and the heater works now. The $85 service call is credited toward the repair if you go ahead.
-
Service call cost?
$85, credited toward the repair when you proceed. Flat-rate quote upfront. 30-day labor warranty.
Google reviews
★★★★★
Eric had a great and warmness about himself, efficient and knowledgeable awareness of the issues. Had accessed and completed the task in a minimal amount of time (12 minutes)
★★★★★
Refrigerator was checked thoroughly and repair ok ok
★★★★★
I’m very glad I had Ivan come to clean the extremely dirty hood over my stove. He came the same afternoon and did a very thorough job. After seeing how much work it was, I was very pleased with the price he charged me. I would definitely recommend this company.
Appliance trouble in Santa Monica? We're on it.
Or text a photo of your appliance so we can bring the right part to Santa Monica.
(213) 205-2055