Skip to main content

Microwave Repair in Van Nuys

A Wolf built-in microwave in Van Nuys ran its light and turntable but never heated. The fuse was open and the magnetron failed its meter check, so both were replaced.

Call or text a photo of the issue. $85 service call, credited to your repair. Online booking in English and Spanish.

Isometric countertop microwave illustration
California BEAR Registered 30-day labor / 90-day warranty on parts we supply $85 service call, credited to your repair Book online in English or Español

Microwave jobs we've documented in Van Nuys

  • Wolf built-in microwave: light on, no heat, no hum

    What the customer saw
    The Wolf built-in above the wall oven lit up and spun the turntable, yet food came out cold, and the microwave stayed silent where it should hum while heating.
    What we found
    The fuse in the high-voltage circuit was open. Since a fuse usually blows for a reason, we also tested the magnetron with a multimeter, and it failed.
    What we did
    We replaced both the magnetron and the fuse, then ran the microwave until it heated again.

Recent jobs in the area

Gloved hand holding the magnetron removed from a Wolf built-in microwave, in front of the opened microwave chassis
Wolf built-in microwave: the magnetron was replaced.📍 Van NuysRead the full case
Wolf built-in microwave above a Wolf wall oven in a kitchen with wood-grain cabinets, next to a built-in Sub-Zero refrigerator
Same job: the Wolf built-in microwave, installed above a Wolf wall oven.📍 Van Nuys

Quick facts

Service call $85 — credited toward the repair when you proceed
Warranty 30-day labor · 90 days on parts we supply
Credentials BEAR #A 50636 · EPA Section 608 Universal
Hours Mon–Fri 09:00–19:00
Sat–Sun 10:00–16:00

Updated November 2026

A Van Nuys microwave that made no sound

The Wolf job in Van Nuys started with a symptom you can hear, or rather can’t. The microwave sits above a Wolf wall oven, next to a built-in Sub-Zero. Its light came on and the turntable turned, but the food stayed cold, and the low hum a microwave makes while it heats never started.

Why the silence matters

That hum comes from the high-voltage transformer and the magnetron. The light, the turntable motor and the fan all run without them. So when everything works except the heat, and the hum is missing, the high-voltage side probably isn’t running at all. That narrows the search to a short list: a fuse in that circuit, the door switches, the control that switches the high-voltage side on, or the high-voltage parts themselves.

The capacitor comes first

Before anything inside gets touched, the microwave is unplugged and the high-voltage capacitor is discharged with an insulated tool, then a meter has to read zero. That capacitor can hold a lethal charge after the plug is out. On a built-in like this Wolf, the unit often has to come out of the cabinet first.

What we found, and why we didn’t stop at the fuse

The fuse was open. A fuse rarely opens for no reason, so we checked the magnetron with a multimeter as well, and it failed. We replaced the magnetron and the fuse, then ran the microwave to confirm it heated again. The photo of the removed magnetron is on this page. Our other written-up microwave job was an install in nearby Valley Village: an LG over-the-range microwave that the customer had started hanging himself and that we finished with new mounting hardware.

If your microwave is lit but cold, stop using it and leave the cover on. Tell us the model and what it does when you press start. We serve all of Los Angeles: the San Fernando Valley, Hollywood and Mid-City, the Westside, and the beach cities and South Bay. Our Wolf appliance repair page covers the rest of that kitchen. Call or text (213) 205-2055.

Frequently asked questions

  • My built-in microwave lights up and turns but doesn't heat. What's wrong?

    Usually something on the high-voltage side, because the light, turntable and fan run without it. On the Wolf we repaired in Van Nuys, the fuse was open and the magnetron had failed. Door switches, the control that switches the high-voltage side on, and the transformer, capacitor and diode can also stop the heat, so each gets checked.

  • Why not just replace the blown fuse?

    Because a fuse usually opens for a reason. On the Van Nuys Wolf, a new fuse alone would have left a failed magnetron in place. We test the magnetron with a multimeter before deciding what to replace.

  • How do you check a magnetron?

    With the power off, the capacitor discharged and the wires off the magnetron, a multimeter reads across the two filament terminals, which should show very low resistance, and from each terminal to the metal case, which should read open. A meter can't show how the magnetron behaves at full power, so the last check is always a heating test.

  • Is it safe to open a microwave myself once it's unplugged?

    No. The high-voltage capacitor can hold a lethal charge after the plug comes out. A technician discharges it with an insulated tool and confirms zero with a meter before touching anything. A built-in like the Wolf often has to come out of the cabinet first, which is one more reason to leave it to us.

  • Do you repair built-in microwaves next to wall ovens in Van Nuys?

    Yes. The Van Nuys job was a Wolf built-in microwave above a Wolf wall oven. We also repair over-the-range and other built-in models across the San Fernando Valley and Los Angeles. Ask about available appointments; timing depends on scheduling and parts.

  • What does a microwave service call cost in Van Nuys?

    The service call is $85, and it's credited toward the repair if you go ahead. The price comes after we diagnose the microwave on site. Labor carries a 30-day warranty and the parts we supply carry 90 days.

Same-day service

Book a diagnostic/repair visit

Please enter your name.
Enter a valid 10-digit US phone number
Please enter a valid email.
Please enter your city or ZIP.
Use JPG, PNG, or WebP — max 3 × 5MB.
No spam, ever Background-checked techs

Microwave Repair in Van Nuys — let's get it scheduled

Or text a photo so we can bring the right part.