Updated November 2026
Quick facts
| Service call | $85 — credited toward the repair when you proceed |
|---|---|
| Warranty | 30-day labor · 90 days on parts we supply |
| Credentials | BEAR #A 50636 · EPA Section 608 Universal |
| Hours | Mon–Fri 09:00–19:00 Sat–Sun 10:00–16:00 |
About appliance service in Studio City
Studio City runs along Ventura Boulevard between Toluca Lake and Sherman Oaks, with hillside homes in the Laurel Canyon foothills, the Colfax Meadows and Carpenter Avenue neighborhoods, and condos and townhomes in and around Studio Village. Our documented jobs here are mostly commercial and HVAC: a school freezer and a rooftop package unit at a sports facility, plus AC and furnace calls. Here we also took the two blowers out of a customer's Viking range hood.
Neighborhoods served: Colfax Meadows, Carpenter Avenue, Laurel Canyon Foothills, Beeman Estates, Studio Village.
ZIP codes: 91604, 91607.
Studio City appliance repair — fast service
We cover both Studio City ZIPs, 91604 and 91607: Colfax Meadows, Carpenter Avenue, the Laurel Canyon foothills, Beeman Estates and Studio Village. Ask about available appointments; timing depends on scheduling and parts, and the $85 service call is credited toward the repair.
Home appliances
We repair premium built-ins and mainstream brands alike, Bosch included. Five jobs from next door: in Sherman Oaks, a GE front-load washer that wouldn’t start on any cycle needed a new main control board, and the first one we fitted was bad, so it took a second board before it ran rinse and spin. In neighboring North Hollywood, a Bosch heat-pump dryer showing error dr couldn’t pump out its water until we wiped the lint and slime from its condensate tray. Over the hill in the Hollywood Hills, a Thermador range showing E0210 had lost two burners and both ovens to a Wi-Fi module that cleaner had corroded. In neighboring Toluca Lake, a stacked Whirlpool Duet Sport washer leaking from a torn door seal got the new seal the customer had ordered. And in neighboring Valley Village, we finished hanging an LG over-the-range microwave that the customer had started putting up himself.
We also work on wine coolers, compressor and thermoelectric, and on the Hollywood Hills side we traced a thermoelectric cooler’s warm top zone to bulged capacitors on its power supply board.
Range hoods
For a hood fan that won’t run or a light that stays off, see range hood repair in Studio City. In October 2026 a customer here couldn’t get the two blowers out of her Viking wall-mount range hood, so we took both out and put them back in.
AC, heating and rooftop units
On the roof of a sports facility here, a Lennox package unit had stopped cooling with its evaporator frozen solid. Nitrogen found a single puncture in one copper tube, so we brazed it on the roof instead of replacing the coil, held a vacuum at 270 microns, recharged it and replaced a worn blower belt. It left with a 23.6°F split. That’s commercial AC repair; our AC repair jobs in Studio City also include a condenser fan motor we replaced and a new condenser we charged with R32 after the replacement. On the heating side, we serviced a gas furnace and got the heat back on (furnace repair). Two mini-split leaks close by came down to dirt at the condensate pump: in neighboring Valley Village, a Daikin with its drain pan outlet and pump filter plugged, and in the neighboring Hollywood Hills, a Carrier with a clogged sponge filter in its pump.
Commercial kitchens
Besides home appliances, we handle commercial appliance repair for businesses in Studio City. The school’s True freezer in the job cards below had a discontinued condenser fan motor; we found an exact match and cleaned the coil before installing it.
Call (213) 205-2055
Or text a photo of your appliance with the model number visible.
Documented jobs in Studio City
-
Commercial freezer at a school that quit cooling
- What the customer saw
- A True commercial freezer at a school in Studio City stopped cooling, and the school's Wi-Fi sensor showed the temperature climbing.
- What we found
- The sealed system checked out fine. The programmable condenser fan motor had stopped spinning, so nothing carried heat off the condenser coil, and that motor is discontinued.
- What we did
- We found an exact match online with the same power, RPM and connection, cleaned the condenser coil, and installed it. The new fan spun and the temperature started coming down.
-
Rooftop package unit frozen solid at a sports facility
- What the customer saw
- The commercial Lennox package unit on the roof of a sports facility in Studio City stopped cooling, and its evaporator was frozen solid.
- What we found
- Nitrogen showed a single puncture in one copper evaporator tube. Because the coil is copper, it could take a braze instead of being replaced.
- What we did
- We brazed the tube on the roof, held a vacuum at 270 microns, recharged to the nameplate and replaced a worn-out blower belt. The unit left with a 23.6°F split between return and supply air.
-
Window AC that shut off the moment it started
- What the customer saw
- In September 2026, a window air conditioner in Studio City shut off the instant it was switched on.
- What we found
- The protective device built into its plug had tripped. Room air conditioner cords are required to carry that device, and a plug that trips right away is reporting a fault in the cord or in itself.
- What we did
- We replaced the whole cord assembly, protective plug included, as one part. The unit itself didn't need replacing, and it runs normally on the new cord.
-
Viking range hood with two blowers the customer couldn't remove
- What the customer saw
- In October 2026 a customer in Studio City was cleaning her stainless Viking wall-mount range hood and couldn't get its two blowers out, so she called us.
- What we found
- We took out both blower assemblies, each a motor with its wheel. Both wheels carried a thick layer of grease built up over many years.
- What we did
- While they were out, she asked us to wash the wheels. We don't offer range hood cleaning as a service. We washed the wheels outside over several rounds, put both blowers back, and the airflow got stronger.
Our recent work in Studio City




Frequently asked questions
-
How fast can you reach Studio City?
Same-day is often possible: call (213) 205-2055 early or book online, and pick one of the open arrival windows. Before we come, text a photo of the model-number sticker so we can bring the right part. Having that part with us is what decides how soon the repair is finished.
-
Do you service entertainment-industry homes?
Yes, and discreetly. We keep client names and street addresses out of our job photos, coordinate access through household staff or property managers when that's how a home works, and provide a certificate of insurance ($1M GL) when building management or a security team asks for one.
-
What brands do you repair in Studio City?
Premium built-ins such as Sub-Zero, Wolf, Viking, Thermador and Miele, and mainstream brands such as Samsung, LG, Whirlpool, KitchenAid, GE and Bosch, from refrigerators and ranges to dishwashers and laundry. The Studio City jobs on this page include a True commercial freezer, a Lennox package unit and a Viking range hood.
-
Do you handle condo buildings in Studio City?
Yes. Studio City has many condo and townhome complexes (particularly along Ventura Boulevard and in Studio Village). We coordinate with property management on building access protocols.
-
Are you available on weekends?
Yes — Saturday and Sunday 10 AM to 4 PM. Ask about available weekend appointments.
-
Have you worked on a range hood in Studio City?
Yes. In October 2026 we took the two blowers out of a customer's stainless Viking wall-mount hood here, since she couldn't remove them herself, and reinstalled both. No parts were replaced.
-
Service call cost?
$85, credited toward the repair when you proceed. Flat-rate quote upfront. 30-day labor warranty and 90 days on parts we supply.
Google reviews
★★★★★
Eric had a great and warmness about himself, efficient and knowledgeable awareness of the issues. Had accessed and completed the task in a minimal amount of time (12 minutes)
★★★★★
Refrigerator was checked thoroughly and repair ok ok
★★★★★
I’m very glad I had Ivan come to clean the extremely dirty hood over my stove. He came the same afternoon and did a very thorough job. After seeing how much work it was, I was very pleased with the price he charged me. I would definitely recommend this company.
Appliance trouble in Studio City? We're on it.
Or text a photo of your appliance so we can bring the right part to Studio City.
(213) 205-2055