Skip to main content

Commercial freezer not cooling at a Studio City school: a discontinued condenser fan motor

The sealed system was fine, but the programmable condenser fan motor had quit, and the original part was quoted at about $1,100.

October 7, 2026 · 4 min read · By Epic Star Service Team, California BEAR-registered, EPA Section 608 Universal certified

Watch: a real Los Angeles repair

Commercial freezer not cooling at a Studio City school: a discontinued condenser fan motor
The old condenser fan motor and the replacement side by side
In this guide

The freezer quit cooling, and the school saw it on their phone

A True commercial freezer at a school in Studio City stopped cooling. The school had it hooked up to a Wi-Fi sensor, so they could check the temperature on their phone. At some point it shot up, and then the freezer quit cooling completely.

Sealed system fine, condenser fan stopped

We pulled the whole unit out. On this freezer, you unscrew a plate, and it all slides out.

The unit pulled out of the commercial freezer to check it

The sealed system checked out fine. What wasn’t working was the condenser fan motor: it had stopped spinning.

That fan pulls air across the condenser coil, and the moving air carries heat away from it. With the fan stopped, nothing cools the coil, and the whole system stops cooling.

Dirty condenser coil fins on the commercial freezer before cleaning

A discontinued motor, quoted at about $1,100

This isn’t a basic fan motor. It’s a high-end, programmable one, and it’s discontinued, so it was hard to find. Replacements were expensive, and the quote for one came to about $1,100.

After searching online, we found a motor that looked the same. It turned out to be an exact match, with the same power, the same RPM and the same connection. The photo at the top of the page shows the old motor and the new one side by side, and you can see both labels in the video. The new one cost a fraction of what supply stores ask for the original part.

Cleaning the condenser coil first

The coil needed cleaning, so it came first, before the new motor went in.

We started with a vacuum and took the loose dirt off, all the way across the coil. Then we went over the fins with a brush, up and down, to loosen up the rest.

Vacuuming loose dirt off the condenser coil

Brushing along the condenser coil fins

Next, we covered the coil in foaming chemical cleaner, left to right, then the sides and the top. The foam gets in between the fins. After that, we rinsed it all off with a pump sprayer, back and forth, until the coil was clean.

Foaming chemical cleaner covering the condenser coil

Rinsing the condenser coil with a pump sprayer

New motor in, temperature coming down

With the coil clean, the new motor went in, and the new fan is spinning. Everything works. The temperature started coming down, slowly.

The cleaned condenser coil back in place, with the old fan motor in hand

If your commercial freezer stops cooling

On this freezer, the sealed system was fine and the condenser fan motor was the problem. If the motor in your unit turns out to be discontinued, ask about an exact match with the same power, RPM and connection before you pay for the original part.

If yours is a home refrigerator or freezer instead, our guide to cleaning refrigerator condenser coils covers the basics, and a home freezer that has stopped cooling is covered on our freezer repair page.

A fan motor that quits isn’t the only reason a commercial cooler stops holding temperature. A glass-door cooler froze its coil solid because a relay in its controller never let the compressor stop, and a bakery’s walk-in froze up twice because its temperature was set far too low.

Commercial refrigeration repair in Studio City

We repair commercial freezers and refrigerators in Studio City and across Los Angeles. Read more about our commercial appliance repair and commercial refrigerator and freezer repair services, or see the Studio City service area. CA BEAR registered (#A 50636), EPA Section 608 Universal certified.

FAQ

Why would a commercial freezer stop cooling when the sealed system is fine?

On this freezer, the condenser fan motor had stopped spinning. That fan moves air across the condenser coil, and without it nothing cools the coil, so the whole system stops cooling.

What if the condenser fan motor is discontinued?

That's what happened here. The original programmable motor is discontinued, and the quote for one was about $1,100. After searching online, we found a motor that turned out to be an exact match, with the same power, RPM and connection, for a fraction of that price.

How do you clean a commercial freezer condenser coil?

On this job, we vacuumed the loose dirt off first, then went over the fins with a brush. Next, we covered the coil in foaming chemical cleaner and rinsed it all off with a pump sprayer. The coil got cleaned before the new motor went in.

Does a Wi-Fi temperature sensor help with a commercial freezer?

It did for this school. They check the freezer's temperature on their phone, and they saw it shoot up before the freezer quit cooling completely.

Do you repair commercial freezers in Studio City?

Yes. This job was at a school in Studio City, and we repair commercial freezers and refrigerators across Los Angeles. The $85 service call is credited toward the repair, and repairs come with a 30-day labor warranty and a 90-day warranty on parts we supply. Call or text (213) 205-2055.

Got an appliance that needs fixing? We cover LA and the Valley.

Call (213) 205-2055 or text a photo of your appliance.