Thermoelectric wine cooler in Hollywood Hills with a warm top zone: bulged capacitors on the power supply board
This cooler has no compressor and no freon. One half of its power supply board was giving the top Peltier module 3.4 volts.
Watch this repair on its own page
In this guide
A wine cooler with no compressor
This wine cooler in Hollywood Hills is an unusual fridge: it cools with Peltier elements, with no compressor and no freon at all. The complaint was the top zone: it wasn’t cooling.
The rating label reads Wine Enthusiast, 18-Bottle Dual Zone Wine Cellar, model 272 03 18 03, 90 W. Its wiring diagram shows two thermoelectric modules.

The bottom cools, the top stays warm
The cooler was unplugged when we got there. We plugged it in, and the bottom section started cooling fast. The top section didn’t cool at all.

A heatsink and a fan for each zone
Inside, there’s a heatsink with a fan up top and another one down below. Around the back it’s the same: one heatsink with a fan for the top zone, one for the bottom.
The bottom fan was running the way it should. The top one was hardly moving.

More airflow didn’t help
We laid the cooler down to take the back cover off. Then we tried cooling the top heatsink with another fan, just to give it more airflow. The temperature still didn’t come down. So the fan wasn’t the cause.

Two power supplies on one board
Now look at the board. There are two power supplies on it. One feeds the top section and the other feeds the bottom, and the two halves mirror each other.

On the left, the filter capacitors are fine, with flat tops. On the right they’ve swollen up. That’s the half for the top zone.

With its filter capacitors swollen, that half couldn’t hold its voltage, so the top zone couldn’t cool.
3.4 volts on one half, about 10 on the other
We measured what goes to the top Peltier module: 3.4 volts. That’s a huge drop.

The other half feeds the bottom section, and it measured 10.3 volts. It sags a bit too: the board’s own label has 10.5 V ticked as the output. That zone still cools fine.

The board is repairable
We can repair this board. Replacing the whole board wasn’t worth it. In the end the customer bought a new cooler, so we left the board as it was.
If your wine cooler has one warm zone, tell us which zone it is when you call, and whether both fans at the back are spinning.
Two more jobs where a capacitor was behind the fault: a GE refrigerator control board with bulged capacitors and an AC in Hollywood Hills where a failed capacitor burned out the condenser fan motor.
Wine cooler service in Hollywood Hills
We work on thermoelectric and compressor wine coolers in Hollywood Hills and across Los Angeles. Read more about our wine cooler repair service, or see the Hollywood Hills service area. CA BEAR registered (#A 50636). Call or text (213) 205-2055.
FAQ
Why is one zone of my thermoelectric wine cooler warm while the other one cools?
On this cooler each zone had its own power supply, and both sat on one board. The filter capacitors on the top zone's half had swollen up, so that half couldn't hold its voltage. We measured 3.4 volts going to the top Peltier module and about 10 volts on the half that was still cooling.
Does a thermoelectric wine cooler have a compressor or refrigerant?
No. This one cools with Peltier elements. It has no compressor and no freon in it.
The fan on the warm zone is barely spinning. Is the fan the problem?
On this cooler it wasn't. We gave that heatsink more airflow with another fan and the temperature still didn't come down, so we moved on to the power supply board.
What do bad capacitors look like?
On this board, one pair had flat tops and the pair on the failed half had bulged tops. The photo in this article shows both pairs side by side.
What voltage should the Peltier module get?
We can only speak for this board. Its label has 10.5 V ticked as the output. The working half measured 10.3 volts and the failed half 3.4 volts.
Can the power supply board be fixed, or does it need a new one?
This board is repairable, and replacing the whole board wasn't worth it. In this case the customer chose to buy a new cooler, so we left the board as it was.
Do you work on wine coolers in Hollywood Hills?
Yes, in Hollywood Hills and across Los Angeles, both thermoelectric and compressor models. Call or text (213) 205-2055, and tell us which zone is warm.
Got an appliance that needs fixing? We cover LA and the Valley.
Call (213) 205-2055 or text a photo of your appliance.