Whirlpool Duet Sport washer leaking at the door in Toluca Lake: new door seal, dryer left on top
The washer was fairly old and stacked under its matching dryer. The customer ordered the new door seal himself, and there was enough room at the back and the front to take the washer apart without unstacking the pair.
In this guide
An old Duet Sport leaking at the door
In October 2026, we worked on a fairly old Whirlpool Duet Sport front-load washer in Toluca Lake. It sits under the matching Duet Sport dryer in an outdoor laundry closet. The door boot seal, the rubber ring between the door opening and the tub, was old and torn, and the washer leaked there.
The customer had already ordered a new seal himself. He asked us to put it in.
Taking the washer apart with the dryer on top
On a stacked pair, the dryer sits right on top of the washer, and on some installations that means lifting the dryer off before the washer can be opened. Here there was decent access to both the back and the front of the washer, so we took it apart without taking the dryer off the stack.
In the photo below, the washer’s front panel is off and its control console is tilted, with the dryer still above it. The old seal, the dark one, is in a gloved hand. The new one, lighter gray, lies on the floor next to the wire clamp ring. Behind them you can see the concrete counterweight around the tub opening and the drain pump at the bottom of the cabinet.

Back together and dry
We fitted the new seal and put the washer back together. It works, and the door seal doesn’t leak anymore. The photo at the top of this page shows the washer after the job, closed up under the dryer.
How do you tell a door seal leak from other front-loader leaks?
The door seal on a front-load washer is a rubber boot clamped to the tub at one end and to the cabinet at the other. When the door is shut, it presses against the seal. During a cycle, water splashes against the seal and runs down into its bottom folds, so a tear or worn spot low on the seal lets water out under the door.
A front-loader can leak from other places too, and where the water appears is the first clue. This is general guidance, and your model’s manual shows where its parts are.
A door seal leak shows up at the front, under the door, while the washer runs. Pull back the folds of the rubber all the way around and look for tears, holes or worn spots.
A leak from the detergent drawer drips from the top front, mostly while the washer fills. Too much detergent or a clogged drawer can cause it.
Many front-loaders have a drain pump filter behind a small panel at the bottom front. A cap that isn’t screwed in tight lets water out low at the front.
Water at the back of the machine points to the hoses. Check the fill hoses where they connect, and the drain hose.
If you can’t tell, put a dry towel under the front and another at the back, then run a cycle and see which one gets wet.
Ordering a door seal yourself
Order by the full model number from the sticker on the washer. A series name such as “Duet Sport” isn’t enough to pick the right part. Compare the new seal with the old one before anything comes apart, and check whether the clamp rings come with it.
When we install a part you bought, our 30-day labor warranty covers our work. The part itself carries no warranty from us, and responsibility for it stays with you; our 90-day parts warranty applies only to parts we supply. The warranty page has the full terms.
Is a new door seal worth it on an old washer?
On a washer that otherwise runs well, the door seal is one part, and replacing it keeps a working machine in use. This customer chose that and ordered the seal himself. If the washer has other faults as well, get a price for everything it needs before you decide. Our repair or replace guide covers how to weigh it.
Washer repair in Toluca Lake
Epic Star Appliance Repair and HVAC repairs washers, stacked pairs included, in Toluca Lake and across Los Angeles. On a stacked LG WashTower in Marina del Rey we replaced a door boot full of mold, and in Burbank a stacked LG washer stopped on an OE error because of its drain pump. CA BEAR registered (#A 50636). Call or text (213) 205-2055 and send a photo of the model sticker.
FAQ
How do I know if my front-load washer is leaking from the door seal?
Look at where the water shows up and when. A torn door seal leaks at the front, under the door, while the washer runs and the drum turns. Open the door and pull back the folds of the rubber all the way around, including the bottom, to look for a tear or hole. On the Whirlpool Duet Sport we worked on in Toluca Lake, the old seal was torn.
Can the door seal be replaced on a stacked washer without taking the dryer off?
Sometimes. It depends on the model and how much room there is around the pair. On a Whirlpool Duet Sport we worked on in Toluca Lake there was decent access to both the back and the front of the washer, so we took it apart with the dryer still on top. In a tight closet the dryer may have to come down first.
Can I buy the door seal myself and have you install it?
Yes. On a Whirlpool Duet Sport job in Toluca Lake the customer ordered the seal himself and asked us to fit it, and we did. Order by the full model number from the washer's sticker. Our 30-day labor warranty covers our work. A part you provide yourself carries no warranty from us, and responsibility for it stays with you; the 90-day parts warranty applies to parts we supply.
What should I check before ordering a washer door seal?
Read the full model number off the sticker on the washer and order the seal listed for that exact number, not for the series name alone. Compare the photo of the new seal with your old one, and check whether clamp rings come with it. Keep the old seal until the new one is in.
Is it worth replacing the door seal on an old front-load washer?
If the rest of the washer runs well, a door seal is a single part and fixing the leak keeps a working machine in service. The customer on our Toluca Lake job chose that for his old Duet Sport. If the washer also has other faults, get a price for all of them before deciding, and weigh that against a new washer.
Do you repair washers in Toluca Lake?
Yes. Epic Star Appliance Repair and HVAC repairs washers in Toluca Lake and across Los Angeles. The $85 service call is credited toward the repair when you go ahead. Call or text (213) 205-2055 and send a photo of the model sticker.
Got an appliance that needs fixing? We cover LA and the Valley.
Call (213) 205-2055 or text a photo of your appliance.