Skip to main content

Commercial Refrigerator Repair in Santa Monica

Prep tables, reach-ins, under-counter units, display coolers and walk-ins for Santa Monica restaurants and businesses, across 90401–90405.

Call or text a photo of the issue. $85 service call, credited to your repair. Online booking in English and Spanish.

Stainless steel Turbo Air refrigerated prep table with two doors and a small digital display in a restaurant kitchen
Turbo Air prep table at a Santa Monica restaurant that read 78°F: the compressor and the condenser fan got no power because of a burnt relay joint on the control board.
California BEAR Registered 30-day labor / 90-day warranty on parts we supply $85 service call, credited to your repair Book online in English or Español

Commercial refrigeration jobs we've documented in Santa Monica

  • Turbo Air prep table at 78°F, fixed without a new compressor

    What the customer saw
    The display on a restaurant's Turbo Air MST-48-N read 78°F. The evaporator fan ran, and the owner expected a new compressor.
    What we found
    The compressor and condenser fan had no power. We read 0 volts across the connector and 120 volts from each pin to ground: an open neutral, broken at a burnt joint on the big relay.
    What we did
    New boards are hard to order, so we fixed this one: new relay, restored contacts, the other joints resoldered. After its start delay the compressor ran and the display began dropping.

    Watch: a real job in Santa Monica

    Turbo Air prep table at 78°F, fixed without a new compressor

Recent jobs in the area

Hand holding a soldering iron over the solder side of the prep table's control board on a blue work mat
Same job: repairing the prep table's hard-to-order control board, with a new relay, the burnt contacts restored and the other joints resoldered.📍 Santa Monica

Quick facts

Service call $85 — credited toward the repair when you proceed
Warranty 30-day labor · 90 days on parts we supply
Credentials BEAR #A 50636 · EPA Section 608 Universal
Hours Mon–Fri 09:00–19:00
Sat–Sun 10:00–16:00

Updated November 2026

Commercial refrigerator repair in Santa Monica

When a prep table or reach-in quits, a kitchen loses a station in the middle of service. We repair commercial refrigeration across Santa Monica, 90401 through 90405: Downtown and the Promenade, Main Street, Montana Avenue, Wilshire and Pico. We work on prep tables, reach-ins, under-counter units, glass-door display coolers, walk-ins and ice machines. We fix what you already have and don’t install new refrigeration systems.

A prep table that didn’t need a compressor

A restaurant here called about a Turbo Air MST-48-N prep table reading 78°F. The evaporator fan ran, the compressor and condenser fan didn’t, and the owner was sure the compressor was gone. At the compressor connector we read 0 volts across the pins and 120 volts from each pin to ground, which points to an open neutral.

The break was on the back of the high-voltage board, at a burnt joint on the big relay that switches the compressor. That board is hard to order, so we replaced the relay, restored the burnt contacts and resoldered the other joints. After the built-in start delay, the compressor and fan ran and the temperature started coming down.

Before anyone orders a part

A warm box can come from a coil packed with grease and dust, a fan motor, a leak, a worn gasket or a fault on the control side. So we start by seeing what still runs, test the power, and quote after that. If your unit has been cutting out and coming back, especially once it warms up, tell us on the phone: a cracked solder joint can act that way. The voltage checks are done live, so leave them to a technician.

When a new board isn’t an option

Some boards are hard to find and some are gone for good. On an oven whose control board was discontinued, we also replaced a burnt relay right on the board. Whether a board can be repaired depends on what burned, and we’ll tell you once we’ve looked at it.

Other commercial refrigeration we’ve repaired around LA

Outside Santa Monica, a True commercial freezer at a Studio City school needed a discontinued condenser fan motor, a glass-door cooler in Torrance froze solid behind a stuck relay, and a bakery’s walk-in in Mid-Wilshire iced up because its temperature was set far too low.

See everything we cover on our commercial refrigerator and freezer repair page. For the dining room’s air conditioning, see commercial AC and HVAC repair. For a fridge at home, see refrigerator repair in Santa Monica.

Pricing, accounts and credentials

The service call is $85, credited toward the repair if you go ahead, and you get the price after the on-site diagnosis. Labor carries a 30-day warranty and the parts we supply carry 90 days. Qualified businesses can run on NET 15 or NET 30 terms with one monthly invoice.

EPA Section 608 Universal certified, California BEAR registered (#A 50636), $1,000,000 general liability insurance. Online booking in English and Spanish. Ask about available appointments; timing depends on scheduling and parts.

Call (213) 205-2055

Tell us what the unit is doing and what still runs. A photo of the model sticker helps us bring the right part.

Common Commercial Refrigerator Repair issues in Santa Monica

  • Prep table or reach-in running warm

    A unit that won't hold temperature can have a coil packed with grease and dust, a failed condenser or evaporator fan motor, a refrigerant leak, worn door gaskets or a power fault at the compressor. We test for the cause before we quote a part.

  • Compressor and condenser fan not running

    If the evaporator fan runs but the compressor and condenser fan don't, the next step is a voltage check at the compressor connector. On our Santa Monica prep table, that check found an open neutral, and the compressor ran again after the repair.

  • Evaporator coil frozen into a block of ice

    A controller relay stuck on, a temperature set far too low, settings lost after a power outage or a failed evaporator fan can each do it. Melting the ice is the easy part, so we look for the reason it froze.

  • Walk-in cooler or freezer running warm

    We repair existing walk-ins: iced evaporators, failed defrost, wrong controller settings, door gaskets and closers, and refrigerant leaks. We don't install new walk-ins.

  • Ice machine making little or no ice

    Scale buildup, a clogged water filter or inlet valve, a water pump or float-switch failure, or a fault on the refrigeration side. We descale and service both the water and refrigeration sides.

Frequently asked questions

  • Do you repair commercial refrigerators in Santa Monica?

    Yes, across all Santa Monica ZIP codes, 90401 through 90405. We repair reach-ins, under-counter units, prep tables, glass-door display coolers, walk-ins and ice machines for restaurants and other businesses. We repair existing equipment and don't install new refrigeration systems.

  • My prep table's compressor won't run. Does it need a new one?

    Not necessarily. On a Turbo Air prep table we repaired in Santa Monica, the owner was sure the compressor had failed, but it wasn't getting power. A burnt relay joint on the control board had left the neutral open, and the compressor ran again once we repaired the board. Have the power at the compressor tested before anyone orders one.

  • Can you repair a control board instead of replacing it?

    Sometimes. It depends on the damage and on whether a new board can be found. The board on that Turbo Air table was hard to order, so we replaced the relay, restored the burnt contacts and resoldered the other joints. We'll tell you which way we'd go after the diagnosis.

  • Are you certified for refrigerant work?

    Yes. Section 608 certification is legally required for refrigerant work, and we hold EPA Section 608 Universal. We're also California BEAR registered (#A 50636) and carry $1,000,000 in general liability insurance, with a certificate of insurance available on request.

  • Can you work around our service hours?

    We book commercial refrigeration work around your hours, including early mornings or the gap between lunch and dinner. Ask about available appointments; timing depends on scheduling and parts.

  • What does the service call cost?

    The service call is $85, and it's credited toward the repair if you go ahead. You get the price after the on-site diagnosis. Labor carries a 30-day warranty and the parts we supply carry 90 days.

  • Do you offer NET terms?

    Yes. Qualified businesses can set up NET 15 or NET 30 terms after a short approval, with one consolidated monthly invoice across all units and locations. New accounts start per-visit.

Same-day service

Book a diagnostic/repair visit

Please enter your name.
Enter a valid 10-digit US phone number
Please enter a valid email.
Please enter your city or ZIP.
Use JPG, PNG, or WebP — max 3 × 5MB.
No spam, ever Background-checked techs

Commercial Refrigerator Repair in Santa Monica — let's get it scheduled

Or text a photo so we can bring the right part.