Skip to main content

An Electrolux gas dryer locked up by a cloth in its blower wheel

Culver City, June 2026. The drum wouldn't turn because a piece of fabric had jammed the blower wheel, and on this dryer that wheel rides on the drive motor's shaft. No parts were replaced.

October 20, 2026 · 5 min read · By Epic Star Service Team, California BEAR-registered, EPA Section 608 Universal certified

Titanium Electrolux front-load gas dryer on its pedestal drawer in a laundry room
In this guide

An Electrolux gas dryer that wouldn’t turn

In June 2026 we were called to a laundry room in Culver City with an Electrolux front-load gas dryer, model EFMG517STT0, in titanium on its pedestal drawer. Its rating label says it’s gas-fired, made in Mexico and built in August 2017.

The drum wouldn’t turn. It was practically locked.

What was jamming it

We opened the dryer up to the blower housing and found the problem inside the blower wheel: a piece of fabric, a towel or a rag, had worked its way in and jammed it.

On this dryer the blower wheel is mounted on the shaft of the drive motor. That same motor turns the drum. With the wheel jammed, the motor couldn’t turn, and so the drum couldn’t either.

Electrolux dryer opened up: the blower housing is open and a white cloth is jammed in the blower wheel and hanging out of it, with lint on the wheel and around it

What we did

We pulled the cloth out of the blower wheel, which freed the motor. While the dryer was open we cleaned the lint out of its inside, and we serviced the drum rollers. After that the dryer worked normally.

We didn’t replace any parts on this job.

How a towel ends up in the blower

This part is general guidance about front-load dryers. We can’t say for certain how the cloth got in on this one.

Air leaves the drum through the lint screen and goes on to the blower, which pushes it out through the vent. The screen is there to stop anything bigger than lint. Thin things can still get past it: through a screen that isn’t pushed all the way in, a torn screen, or the gap at the front edge of the drum where a worn seal no longer closes. Washcloths, socks and small rags are thin enough to make it.

Once something reaches the blower wheel, it can wrap around the blades and stop the wheel. On a dryer where that wheel shares a shaft with the drive motor, the drum stops too.

Lint and a gas dryer

A gas dryer heats its air with a burner flame. Lint is fine and it burns easily, and it collects inside the cabinet around the blower and along the air path. The U.S. Fire Administration names failure to clean as the leading cause of home dryer fires. That’s why we cleaned the lint out of this dryer while it was open. At home, the habit that helps most is clearing the lint screen before every load. Our dryer lint and fire prevention guide covers the vent side.

When to stop the dryer and call

If the drum won’t turn, or you hear the motor hum while the drum stays still, stop the dryer and don’t keep restarting it. A motor that can’t turn can overheat.

If you smell burning, turn the dryer off and unplug it. On a gas dryer, also close its gas shutoff valve if you can reach it safely. If you smell gas, don’t touch switches or plugs: leave the house and call the gas company or 911 from outside. We repair the dryer itself; we don’t work on gas piping.

Electrolux dryer repair in Culver City

We repair Electrolux gas and electric dryers in Culver City and across all of Los Angeles: the San Fernando Valley, Hollywood and Mid-City, the Westside, and the beach cities and South Bay. See our dryer repair in Culver City page, our dryer repair service and our Electrolux appliance repair page. The service call is $85, credited toward the repair. Repairs carry a 30-day labor warranty and 90 days on parts we supply. CA BEAR registered (#A 50636), EPA Section 608 Universal certified. Call or text (213) 205-2055.

FAQ

How can a towel stop the whole dryer?

On this Electrolux the blower wheel is mounted on the shaft of the drive motor, and the same motor turns the drum. A piece of fabric got inside the blower wheel and jammed it, so the motor couldn't turn, and neither could the drum. Once we pulled the cloth out, the motor and the drum were free again.

Did you replace any parts on this dryer?

No. We removed the cloth from the blower wheel, cleaned the lint inside the dryer and serviced the drum rollers. After that the dryer worked normally, with no new parts.

How do small items get past the lint screen?

This is general guidance, and we can't say how the cloth got in on this particular dryer. A lint screen that isn't pushed all the way in, a torn screen, or a worn seal at the front edge of the drum can leave a gap. Thin things like washcloths, socks and small rags can slip through it and reach the blower.

Is lint inside a gas dryer dangerous?

It can be. Lint burns easily, and a gas dryer heats its air with a burner flame. The U.S. Fire Administration names failure to clean as the leading cause of home dryer fires. Clean the lint screen before every load and have the inside and the vent cleaned when the dryer is opened for service.

Do you repair Electrolux gas dryers in Culver City?

Yes, in Culver City and across all of Los Angeles. We work on the dryer itself and don't do gas piping. The service call is $85 and is credited toward the repair. Repairs carry a 30-day labor warranty and a 90-day warranty on parts we supply. Call or text (213) 205-2055.

Got an appliance that needs fixing? We cover LA and the Valley.

Call (213) 205-2055 or text a photo of your appliance.